HEIDENHAIN MANUALPLUS 620 - Page 592

592 HEIDENHAIN Technical Manual MANUALplus 620
convTblNr
600417
Conversion table to be activated
Enter the number of the conversion table that is to
be activated when this tool holder is inserted.
Format: Numerical value
Input: 0: Do not perform any conversion
1: Activate conversion table 1
(file: conv1.hc)
2: Activate conversion table 2
(file: conv2.hc)
3: Activate conversion table 3
(file: conv3.hc)
RESET
LEVEL3
1403
RearSideMachining
CfgRearSideKinem
Kinematic configurations for rear-face machining
[Key name of the machining channel]
Two channels are permanently defined:
 CH_NC: Machining channel
 CH_SIM: Simulation channel
kinList
605701
Kinematic configurations for rear-face
machining
Enter here the key names of all kinematic
configurations for rear-face machining
Format: List [0 to 100]
Input: Selection menu
Kinematic models off
CfgKinComposModel
RUN
LEVEL1
1462
specWpSpindleList
605702
Workpiece spindles for rear-face machining
Enter the key names of all workpiece spindles with
special transformations for rear-face machining.
Format: List [0 to 100]
Input: Selection menu
Spindle key names from
Axes/PhysicalAxis
RUN
LEVEL1
1462
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page