HEIDENHAIN MANUALPLUS 620 - Page 593

January 2012 4.10 List of Machine Parameters 593
CfgRearSideTrafo
Transformations for rear-face machining
[Key name of the spindle for rear-face machining]
mirAxis
605804
Axis to be mirrored
Enter the axes for which transformations for
mirroring are to be assigned in MP_trafoMirAxis.
The transformation is assigned to the axis through
the list index.
Format: List [0 to 100]
Input: Selection menu
Key names from
Axes/PhysicalAxis
RUN
LEVEL1
1462
trafoMirAxis
605801
Transformations for axis mirroring
For the axes located in MP_mirAxis, enter here the
transformations for mirroring axes. The
transformation is assigned to the axis through the
list index.
Format: List [0 to 100]
Input: Selection menu
Key names from
CfgKinSimpleTrans
RUN
LEVEL1
1462
toolLengthDir
605805
Axis directions of the mirrored tool lengths
Enter here the axis directions of the mirrored tool
lengths for which MP_trafoMirToolLength
contains transformations for mirroring of the tool
lengths. The transformation is assigned to the axis
through the list index.
Format: List [0 to 100]
Input: Selection menu
XAxis
YAxis
ZAxis
SpecAxis
RUN
LEVEL1
1462
trafoMirToolLength
605802
Transformations for mirroring the tool length
For the axis directions located in
MP_toolLengthDir, enter here the
transformations for mirroring the tool lengths. The
transformation is assigned to the direction of the
mirrored tool length through the list index.
Format: List [0 to 100]
Input: Selection menu
Key names from
CfgKinSimpleTrans
RUN
LEVEL1
1463
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page