HEIDENHAIN MANUALPLUS 620 - Page 68

68 HEIDENHAIN Technical Manual MANUALplus 620
401510 CfgSpindle MP_kvFactorM19 kv factor for spindle orientation,
see page 1004.
401511 MP_kvFactorTapping kv factor for tapping, see page
1039.
401512 MP_kvFactorSync kv factor for spindle synchronism,
see page 1033.
401606
401607
CfgPositionFilter MP_shape Shape of the nominal position
value filter, see page 814.
401606
401607
MP_frequency Limit frequency of the nominal
position value filter, see page 814.
401606
401607
MP_hscMode Operating mode of the nominal
position value filter, see page 814.
401608 CfgPositionFilter MP_handwheelFiltOrder Order of the mean-filter value in
the Electronic Handwheel mode,
see page 814.
402301 CfgAxisCoupling MP_masterAxis Synchronized axes: Assign a
master axis to the slave axis, see
page 764.
402302 MP_mode Synchronized axes: Mode of the
coupling, see page 764.
402303 MP_type Synchronized axes: Type of
coupling, see page 764.
402304 MP_typeOfOffset Synchronized axes: The
parameter specifies how the
position offset between master
and slave axis is treated, see page
764.
402305 MP_posOffset Synchronized axes: Value of the
position offset with closed
coupling, see page 764.
402306 MP_offsetFeed Synchronized axes: The velocity
with which an offset between the
master axis and the slave axis is
compensated for, see page 764.
402307 MP_maxPosDiff Synchronized axes:
Synchronization monitoring –
deletable emergency stop
message, see page 764.
402308 MP_ultimatePosDiff Synchronized axes:
Synchronization monitoring – non-
deletable emergency stop
message, see page 764.
402309 MP_scalingFactor Synchronized axes: Scaling factor
for calculating the slave position,
see page 764.
MP
number
Config object Parameter Description