January 2012 1.3 NC Software 548 328-04 69
402310 MP_torqueBias Synchronized axes: Tensioning
torque between master and slave
for master-slave torque control
(entry for the slave axis), see page
764.
402311 MP_propGain Synchronized axes: P factor of the
torque controller for master-slave
torque control (entry for the slave
axis), see page 764.
402314 MP_inverseVelocity Synchronized axes: Reversal of
the algebraic sign of the nominal
speed value, see page 764.
402315 MP_accFilterTime Synchronized axes: Time constant
for filtering the acceleration curve,
see page 764.
402316 MP_autoBrakeTest Run a brake test automatically
with the master axis, see page
764.
403001 CfgDeadStop MP_deadStopLag Max. permissible following error,
see page 1464.
403003 MP_forthTorqueFactor Factor for converting the
programmed force to a torque,
see page 1464.
403004 MP_minTorque Min. limit of current with quill
function, see page 1464.
403005 MP_maxTorque Max. limit of current with quill
function, see page 1464.
403006 MP_torqueTolerance Tolerance window for status
message, see page 1464.
600213 CfgTHDescription MP_coolantCirc List with the numbers of the
allocated coolant circuits, see
page 1399.
601809 CfgGlobalProperties MP_ncStartWithActCyc Program run with the most
recently selected cycle, see page
1417.
602017 CfgGlobalTechPara MP_DefaultM3M4 Rotational direction for new units,
see page 1421.
604804 CfgGlbDispSettings MP_mmiFilePreview Activates file preview during
program selection, see page
1410.
605501 CfgBackup MP_groupList List with the key names of all
backup lists, see page 1794.
605601 CfgBackupGroup MP_backupFiles List with the paths of all
configuration files, see page
1794.
MP
number
Config object Parameter Description
To Next Page
Loading...
