HEIDENHAIN MANUALPLUS 620 - Page 816

816 HEIDENHAIN Technical Manual MANUALplus 620
Example 2:
Machine with 3 axes, with slow infeed of the Z axis
In this 3-axis configuration, all nominal position value filters are defined globally
with the exception of the Z axis. Remove all CfgPositionFilter configuration
objects, except in the parameter set for the Z axis. Since the filter settings will
be reduced for the Z-axis to accommodate the slow infeed movements, this
axis is configured separately:
Warning
Only define separate filter settings for an axis if the axis is not interpolated
with the other axes!
Example:
On a boring mill (boring applications only) it may be useful to define softer
filters for positioning movements in the Z axis at rapid traverse.
Machine parameters in the configuration editor and
recommended input value
Meaning
System
CfgFilter
defaultPosition
shape: HSC
frequency: 40
hscMode: Smoothing
defaultManualOrder: 11
Form of filter: HSC filter
Limit frequency: 40 Hz
HSC mode: Finishing
Filter order in Manual operating
modes: 11
Axes
ParameterSets
[Key name of the Z axis]
CfgPositionFilter
axisPosition
shape: HSC
frequency: 15
hscMode: Smoothing
Form of filter: HSC filter
Limit frequency: 15 Hz
HSC mode: Finishing