Keysight M8000 Series of BER Test Solutions User Guide 127
User Interface - M8020A Display Views 4
Module View
The Module View is a graphical representation of the input/output ports
that are present on the front panel of the modules, configured into the
M8020A/M8030A/M8040A. The M8020A/M8030A supports the M8041A
(8.5/16G Generator, Analyzer, Clock Module), M8051A
(Generator-Analyzer), M8061A (32 Gb/s Multiplexer with De-emphasis)
and M8062A modules that are installed into an Keysight M9505A 5-slot
AXIe chassis. The M8040A supports the M8045A and M8046A modules
that are installed into an Keysight M9505A 5-slot AXIe chassis. These
modules have a different set of input/output ports depending upon their
functionality e.g. generator, analyzer or clock. Each module consists of two
channels (channel 1 and channel 2) depending upon the licenses, you
have ordered. Each channel contains Data Out (Generator) and Data In
(Analyzer) ports.
The modules are identified as M1, M2, M3 and so on in the GUI.
You can use the Module View to configure the properties of a single port
or a group (combination of multiple ports). For details, refer to Group View
on page 185.
How to Launch Module View
The Module View is launched by-default whenever you launch the
M8070A user interface. However, if it is not available or is closed, you still
can launch it.
To do so:
•Go to the Menu Bar > System and then select Module View.
The following figure shows an example of Module View when M8041A
(M1) and M8051A (M2) modules are connected:
To Next Page
Loading...
Need help?
General
