Keysight Technologies M8000 Series

Keysight M8000 Series of BER Test Solutions User Guide 159
User Interface - M8020A Display Views 4
• Amplifier - This block represents the current value of Data Out's
amplitude parameter. You can change the value by clicking on this
block and modify the respective parameter in the Parameters window.
• Delay - Set the delay of the active edge of the data output.
• Data Generation - Acts as the output port for the generator which may
be connected to the DUT.
Trigger
The following section of the System View represents the trigger function:
It allows you to apply settings on the Trigger Out port or location.
It includes the following blocks:
• State - Click on the button to enable the output of Trigger Output
for the channel. Once the output is enabled, the button changes to
“ON” . If you press the button again, it will turn the state “OFF”.
• Amplifier - Use this block to set the parameters related to amplifier of
the trigger output.
• Output Timing - Use this block to set the delay of the active edge of
the trigger output.