Keysight M8000 Series of BER Test Solutions User Guide 411
Setting up Patterns 7
Fills the specified value to the given range in the pattern. You can only
enter the patterns depending upon the pattern mode (Bit coded or
Symbol coded) selected form Data View Mode.
• Invert
Invert the bits. 0 becomes 1 and 1 becomes 0.
•Rotate
This tab provides the following options:
• Rotate Symbol Left by:
Treats the pattern data in the specified range as a circular buffer and
rotates the bits to the left by the specified amount. No data will be lost
and what is at the start of the buffer will be at the end of the buffer
after the rotation.
• Rotate Symbol Right by:
Treats the pattern data in the specified range as a circular buffer and
rotates the bits to the right by the specified amount. No data will be
lost and what is at the end of the buffer will be at the start of the buffer
after the rotation.
• Align to Sequence:
Aligns the pattern data in the specified range to a specified pattern
sequence.
Go To Bit Dialog Box
The Go To dialog box allows you to set the cursor to an arbitrary position in
the pattern.
Enter the bit position (=address) or alternatively you can use the UP and
DOWN arrow buttons to enter the bit position and then click OK. The
cursor will be placed in front of the character with the selected bit.
To Next Page
Loading...
Need help?
General
