Group 7 Data entry/Programming Page 109
JET2 neo Release R1.12 en
Attention! If job counters (object counters) whose settings <Counter
reset> are applied with the attribute „production counter“ exist in the
current job, they will be also reset.
You will find further information regarding the counter reset methods in
the chapter Counter reset (methods) (page 67 and 231)!
7.2.2.4.2 Stop after x products (Pre-defined print stop)
With the option <Stop after x products> the amount of prints will be defined after the
LEIBINGER JET2neo should release an automatic print stop.
If a print stop has been pre-defined the value is displayed in the status field <Production
counter> of the basic menu.
Attention! Before the re-start of the production, the production counter
has to be necessarily reset to get a correct result.
Press on the status field <Product counter> in the basic menu (1) or press the button
<Product counter settings> (2).
The menu <Product counter> (3) is faded in. As standard the register card
<Counter> (4) is activated.
Now click on the register card <Stop> (5) and the current value of the print stop counter
is shown in the display „Stop after x products“ (6).
Change the value of the print stop counter with the +/- buttons (8). The value of the
counter is increased or reduced in increments of one by pressing the appropriate key
and the change displayed directly on the display (9).
or
Click in the display „Stop after x products “ (6). The number block <Product
counter>(7) opens for input.
You will find further information regarding the working with number
blocks in the chapter Number block (page 61)!
To Next Page
Loading...
