Group 7 Data entry/Programming Page 151
JET2 neo Release R1.12 en
Now the data are saved on the connected medium and the symbol <Export is
running ()> (5) is displayed during the process.
After finishing the storage the message (6), that the process has been carried out is
faded in. The saving happens with the description „datalog_Ljet2neo-(“serial number
of the printer”).txt“.
Finally confirm the message with the button <OK ()> (7).
Indications!
After exporting the logfile, the button <Export> is no longer displayed. The
button is only provided again when the menu is re-opened.
If no storage medium (memory device) is connected, the message (8) is
faded in. Confirm the message with the button <OK ()> (9). Connect a
memory device and repeat the complete process.
7.2.4.4 Hydraulic-/Printhead- and special functions
This work must only be carried out by trained personnel or by
Leibinger service technicians!
With the button <Hydraulic/Printhead> (1) you can open the menu „Hydraulic/
Printhead/Special functions“ (2).
This menu provides the verification of hydraulic components, activation or deactivation
and setting of print head functions as well as the processing of special functions. All
changes have only a temporary effect, that means as long as the menu is open.
The selection of a functional area happens by clicking on the accordant register card (3).
Note: The proceeding corresponds to the Windows™-standard procedure.
By pressing the button <Quick Off> (4) the JET2neo is turned off immediately, without
carrying out further actions (e.g. closing the nozzle).
The button <Close> (5) closes the menu.
To Next Page
Loading...
