Leibinger JET2neo - 9.3 Error Messages and Workarounds

Group 8 Job editor Page 255
JET2 neo Release R1.12 en
8.8.2 Close job editor
Figure 151
Close job editor
1 – Button <OK ()>
4 – Button <No>
2 – Safety query
5 – Button <Yes>
3 – Button <Cancel>
With the button <OK ()> (1) you can close the job editor.
If changes have been carried out at the opened job, an accordant safety query (2) is faded
in.
In this case the following possibilities are available:
 Press the button <Cancel> (3) to abort the process and to go back to the editor.
 Press the button <No> (4) to leave the editor without saving the job.
 Press the button <Yes> (5) to save the job when leaving the editor.
Attention!
The saving happens under the current data file name. The existing data will be
overwritten!
1
3
5
2
4