Page 20 Safety Group 2
Release R1.12 en JET2 neo
Only trained personnel must operate the device. The personnel must have appropriate training
to enable them to be able to operate the JET2neo high performance printer professionally.
Within the working area of the LEIBINGER JET2neo device the operator is responsible with
regard to third parties.
The operator must
put this operating manual at the operating staff’s disposal and
make sure that they have read and understood them.
2.6 Dangers due to electric energy
The electrical and electronic components of the high performance printer are
under voltage. The device must only be opened by trained personnel or by
Leibinger service technicians.
Prior to the opening of the device the device must be switched off and the
mains plug removed.
2.7 Personal protective equipment
Materials are processed in this device that cause irritations and which are under pressure. In
order to avoid injury and damage the personnel must wear the following personal protective
equipment during certain work procedures:
suitable work clothing
suitable eye protection
suitable hand protection
More detailed information can be found in the corresponding chapters of this manual as well
as possibly in information and data leaflets of consumables.
2.8 Protective devices and safety concept
In an emergency the device is placed idle by removal of the mains plug.
The device is equipped with the following safety concept to provide explosion protection:
Bottom tub as collecting tray
Jet monitoring in the gutter circuit
To Next Page
Loading...
