Leibinger JET2neo - End Value; Figure 140 - Counter Settings (Initialization Value); Initialization Value

Page 230 Job editor Group 8
Release R1.12 en JET2 neo
8.6.3.2.2 Initialization value
The setting defines the initialization value of the counter. The maximum input is 10 digits.
That means if the job is started or loaded for the first time, it is first counted from the
initialization value to the end value. Afterwards it is then always counted from the start
value to the end value.
The set value is shown on the accordant display field.
Figure 140
Counter settings (Initialization value)
Initial value
Example:
8.6.3.2.3 End value
The setting defines the end value of the counter. The maximum input is 10 digits.
After reaching the end value the counter will be reset to the start value.
The set value is shown on the accordant display field.
End
value
Start
value