Leibinger JET2neo - Basic Settings; Figure 60 Menu Basic Settings

Group 7 Data entry/Programming Page 115
JET2 neo Release R1.12 en
7.2.3.1 Basic settings
With the button <Basic settings> (1) the menu „Basic settings“ (2) opens.
This menu serves as setting of
 Language/Unit (Measurement)
 Interval function
 IP-address
 Date /Time
 Encoder interface
and to reset the device to the factory settings.
The selection of a functional area happens by clicking on the accordant register card.
Note: The proceeding corresponds to the Windows™-standard procedure.
The button <OK ()> closes the menu.
Figure 60
Menu basic settings
1 – Button <Basic settings>
5 – Register card <Interfaces>
2 – Register card <Language/Unit>
6 – Register card <IP-Address>
3 – Register card<Date/Time>
7 – Button <OK ()>
5 – Register card<Interval>
1
6
7
3
4
5
2