Group 10 Equipping/Maintenance Page 271
JET2 neo Release R1.12 en
10.3.1 Cleaning the print head
Dangerous electrical voltage!
Contact causes serious damage through an electric shock!
Disconnect the device from the mains supply prior to opening.
Remove mains plug!
Inflammable (Risk of fire)!
Combustible gases and liquids cause serious burns. Sources of
ignition must be kept away from the print head and the device!
Risk of injury!
Ink escapes from the head aperture. Spraying of ink into the eyes can
cause blindness. Eye protection is necessary!
Risk of injury!
Upon contact the contents causes skin irritation. Protective
equipment is necessary!
The print head must be checked daily and cleaned in the event of recognisable dirt through
penetrating dust or ink. In this respect high release of solvent vapours should be avoided
through the economical use of Leibinger solvent (corresponding to the Leibinger ink). This
is achieved through applying the Leibinger solvent to fluff-free paper with the spray bottle
and wiping off the parts to be cleaned with this. Direct spraying off of the print head with
solvent should only be carried out with very major dirt and should be limited to the front
part of the print head. Following intensive cleaning the nozzle seal must be lubricated with
a commercially available oil (spindle and guide). Oil must not get into the gutter (back
absorption)! Solvent dropping down must be collected using a solvent resistant metal
vessel and disposed of properly.
This work must only be carried out by trained personnel or by
Leibinger service technicians!
To Next Page
Loading...
