Leibinger JET2neo - 10.3 Print Head Cleaning

Group 10 Equipping/Maintenance Page 269
JET2 neo Release R1.12 en
10.2.4 Other servicing work
10.2.4.1 Replacement of the battery
Dangerous electrical voltage!
Contact causes serious damage through an electric shock!
Disconnect the device from the mains supply prior to opening.
Remove mains plug!
Caution! – Danger of explosion and of short circuit!
Risk of explosion and of short circuit in the event of incorrect
replacement of the battery!
Replacement of the battery!
This work must only be carried out by trained personnel or by
Leibinger service technicians!
The battery is situated in the electronics housing on the controller board. If necessary the
battery must be replaced. For the change of the battery you have to observe the following
safety- and disposal instructions as well as the disposal directions and the disposal
directions of the battery manufacturer!
Safety- and disposal instructions
1.
Please only replace with the same battery or with a comparable type
of battery according to the recommendation of the manufacturer!
Danger of
explosion
2.
Pay attention to the correct polarity (+/-)!
3.
Do not throw battery into fire!
4.
Do not load battery again!
5.
Do not use conductive tools to change the battery!
Danger of
short circuit
6.
Do not open battery!
7.
Do not dispose battery in the household garbage!