Leibinger JET2neo - Basic Operating Processes; General; Initialization of the Device; Figure 21 - Initialization Process

Group 6 Operation – Elements and procedures Page 63
JET2 neo Release R1.12 en
6.5 Basic operating processes
This paragraph describes the basic operating processes of the LEIBINGER JET2neo.
6.5.1 General
The complete control of the JET2neo can be carried out with a connected PC-mouse or
directly with the TFT-Touch-Display.
For the operation with the Touch-Display the control of the device happens by a slight
touch on the buttons (touch-fields) with the finger or with the touch pin (included in the
delivery). Here the targeted precision is decisive and not the pressure.
The operation with the touch-display is described subsequently.
Accidentally touching can release unintentional device conditions.
6.5.2 Initialization of the device
After connection to the mains power or after a power interruption, the initialization of the
device will be carried out automatically. For this procedure the boot-manager is started.
The progress of the initialization is shown by a bar. After finishing the process the device
is switched to the standby-mode (monitor is dark) and the JET2neo is now ready to switch
on by pressing the touch screen.
Figure 21
Initialization process
1 – Bootmanager
2 – Progress display
1
2