Leibinger JET2neo - Counting Direction; Leading Zeros (Left-Hand Zeros); Repetitions; Step Width

Group 8 Job editor Page 227
JET2 neo Release R1.12 en
8.6.3.1.2 Step width
The setting defines the increasing of the counter between the several prints.
The set value is shown on the accordant display field.
8.6.3.1.3 Repetitions
The setting defines the amount of prints which should be repeated. If no repetition is
requested, you have to enter „0“. The counter can print up to 999998-times repetitive.
Example
:
0 = No repetition
1 = Every counter value is printed twice consecutively (1repetition)
2 = Every counter value is printed triply consecutively
(2 repetitions)
……
The set value is shown on the accordant display field.
8.6.3.1.4 Leading zeros (left-hand zeros)
With this function the display of the leading zeros of a counter are turned on or off.
Example: 4-digits counter
Function
Value
Display
deactivated
1
1
activated
1
0001
8.6.3.1.5 Counting direction
This setting controls the direction of the counting process.
 Counting direction forward: If this control box is activated the counter will be
incremented (+).
 Counting direction backwards: If this control box is activated, the counter will be
decremented (-).