Leibinger JET2neo - Create and Process Graphic Elements; Figure 44 - Graphic Editor (Create Graphic)

Group 7 Data entry/Programming Page 95
JET2 neo Release R1.12 en
7.2.2.1.7 Create and process graphic elements
1. Creation of a graphic element:
(Example.:A rectangle should be created)
Proceeding:
 Press on the drawing tool <Rectangle> (1).
 Click in the grid of the input field on the requested start point (2).
 The requested start point is placed and is marked red. At the same time on the
display <Coordinates> (4) the coordinates of the start points are shown and on the
display <Activities to carry out> (3) you can see the next required or possible
activity.
 Now click in the grid on the requested position of the end point (5). The rectangle is
now created.
Figure 44
Graphic editor (Create graphic)
1 – Drawing tool <Rectangle>
4 – Display <Coordinates>
2 – Start point
5 – End point (Rectangle)
3 – Display <Activities to carry out>
1
2
4
3
4
5
3