Page 272 Appendix Group 12
Release R1.12 en JET2 neo
11. Taking out of operation/Dismantling
11.1 Taking out of operation
The ink and solvent which still remains in the high performance printer have to be removed.
For this a special draining routine is available.
You will find further information regarding the procedure of draining in the
chapter Special functions under the point Drain routine! (page158)
Dangerous material in the machine!
Read the safety leaflets and the regulations on personal safety equipment!
Now the high performance printer has to be turned off and disconnected from the mains supply.
Further more you have to disconnect possible connected additional devices. You will find the
capabilities of connecting lateral at the electronic-cabinet of the device. You have to follow
the instructions of the several devices!
Finally you have to clean the device of dirt, ink rests etc. as described in the chapter Cleaning.
11.2 Dismantling/Disposal
The LEIBINGER JET2neo has been developed and built with materials that ensure problem-
free dismantling and disposal. When dismantling, the information in the chapter Taking out
of operation as well as the respective country specific disposal regulations (e.g. for inks and
solvents) must be taken into consideration
To Next Page
Loading...
