Leibinger JET2neo - Figure 123 Printgo-Holdoff Distance; Printgo-Holdoff Distance

Page 196 Job editor Group 8
Release R1.12 en JET2 neo
8.5.2.1.4 PrintGo-holdoff distance
The setting provides a filtering of unrequested PrintGo-signals (e.g. PrintGo with bounces
or double releases). The value defines a length „x“ after the PrintGo-signal in which every
further signal will be ignored.
The input is carried out in the measurement which has been selected in the basic settings.
The set value is shown on the accordant display field.
Figure 123
PrintGo-holdoff distance
PrintGo with „chatters“:
Double releases:
PG Signal(s)
PG Signal(s)
Filtering active
Filtering active
Printer’s
imprint
Printer’s
imprint
Object which
should be printed
Text Text Text Text Text Text