Leibinger JET2neo - Execution of the TAG-Activation and Refilling; Figure 153 - TAG-Reader and Re-Filling Bottle; TAG-Reader

Page 260 Equipping/Maintenance Group 10
Release R1.12 en JET2 neo
10.1.1.2 TAG-reader
The TAG-reader of the Leibinger JET2neo printer is a guarantee for the faultless function
from side of ink and solvent.
Because of the TAG-reader the printer only allows only the usage of the set up ink and
solvent from LEIBINGER. So we can make sure that only released ink and solvent is used.
If the printer is refilled with ink or solvent so the printer will ask for the so called TAG-
activation. If this activation is not be carried out the printer will shut down und do not allow
any operation. That’s why there is no production able anymore. Every TAG can only be
activated once.
Figure 153
TAG-reader and re-filling bottle
1 – Reservoir tank „Ink“
4 – 7 – Re-filling bottle (ex. Solvent)
2 – Reservoir tank „Solvent“
5 – TAG area of the re-fill bottle
3 – TAG reader
10.1.1.3 Execution of the TAG-activation and refilling
The reservoir tanks should be not overfilled!
The refilling of the reservoir tanks must only be carried out if the printer
gives a message that the reservoir tank is empty!
Is one of the reservoir tanks empty the printer gives you a refilling message on the touch
display.
1
2
3
5
4