Page 70 Operation – Elements and procedures Group 6
Release R1.12 en JET2 neo
Press on the status field <Product counter> (1).
The menu <Product counter> (2) is faded in. As standard the register card <Counter>
(3) is activated and the current value of the counter appears in the display „Product
counter“ (4).
Change the value of the counter with the +/- buttons (6). The value of the counter is
increased or reduced in increments of one by pressing the appropriate key and the
change is shown directly in the display (4).
or
Click in the product counter display field (4). The number block <Product
counter> (5) opens for input.
You will find further information regarding the operation with number blocks
in chapter Number blocks (page 61)!
Confirm the change of values by pressing on the button <Set> (7).
Then press the button <Close> (8) to complete the process and exit the menu.
6.5.6 Product counter – pre-defined print stop
Further information about setting up a pre-defined print stop can be found
in the chapter Stop after x products (pre-defined print stop) (page
109)!
To Next Page
Loading...
