Group 7 Data entry/Programming Page 161
JET2 neo Release R1.12 en
The signal which is pending at the interface is only analyzed by the JET2neo if the
function <Extern Ink on/off active> is turned on.
5. Piezo test and charge test
Dangerous electrical voltage in the printhead!
Have measurements on live parts done by qualified
electricians only! This work may only be carried out
by approved personnel or Leibinger Service
technicians!
Oscillator voltage setting: Output of a constant oscillator voltage which serves for
matching with the oscillating voltage amplifier (pot TRM 1). The result of the setting
can be read, in the form of a tear-off curve in the display field <Drop-Break-Off
curve> of the functional area „Printhead page 1“.
Charge voltage setting: Output of a constant charge voltage for adjustment of the
charge voltage amplifier (offset TRM 2, gain TRM3).
The button <Piezo test> (1) serves to set the oscillator voltage and the button <Charge
test> (2) to set the charge voltage.
To Next Page
Loading...
