Press the button <Parameter settings> (1) in the menu bar.
The submenu „Parameter settings“ is faded in. As standard, the <Printstyle
position> (3) functional area is displayed.
With the register cards (2) you can change between the several parameters (functional
areas).
Now press the register card <PrintGo2> (4) to open the desired functional area.
Several functions can be activated or deactivated by clicking on the accordant control
box (8) or on the designation.
With the +/- buttons (7) you can increase or reduce the values of the several
parameter settings by one step.
alternatively
By clicking in the accordant display field (5) of the value which should be changed. A
number block (6) opens for input in which you can enter the requested value.
You will find further information regarding the working with number
blocks in the chapter Number block (page 61)!
The button <Close> (9) closes the menu without taking over the changes.
The button <OK ()> (10) closes the menu and the carried out settings will be taken
over.
You will find further information regarding the several parameter
settings and its effects in the chapter Parameter settings (page 188)!
To Next Page
Loading...
