Turn on the printer. For this touch the dark touch-display (1) at any position for approx.
2 sec.
The device turns on and the message<Initialization> (2) is displayed. Wait until the
initialization is finished. After this process the message <Emergency Shutdown> (3)
is displayed.
Press the button <OK ()> (4).
Go to the “Special functions” area by clicking on the appropriate register card (5).
Now press the button <Fill up Routine> (6). The message <Fill up Routine> (7) is
faded-in.
Press the button <Next> (8) to start the filling routine.
Note: This process takes approx. 10 minutes.
After finishing the process an according message (9) is displayed. Press the button
<OK> (10) to finish the routine.
Press the <Close> button (11) to exit the <Special functions> area.
The message <Hydraulic control> (12) is faded-in.
Note:
For leaving the service menu the hydraulic control will be turned on again
automatically.
Press the button <OK () > (13) to close the service menu.
If required the device starts automatically with the bleeding of the system.
During the process the message <Bleeding> (14) is displayed. The bleeding takes
between 1–5 min. The process can be canceled by pressing the button <Cancel> (15).
The basic menu (16) is now displayed and the printer is ready to operate.
To Next Page
Loading...
