IXL-001: Operation and Maintenance 365-575-102
Page 6 of 14 Issue 8.0, July 2002
FT-2000 MULTIPLEXER
Establish Restoration Protection Access in
Point-to-Point Network Circuit Order: NTP-007
Identify Primary/Secondary and
Source/Destination Nodes Operations: NTP-006
Identify Source of Incoming Signal Detailed Level Procedure: DLP-535
Inspect (Repair) Optical and/or Electrical
Cable(s) Detailed Level Procedure: DLP-528
Install and/or Remove Optical Loopback at OC48
REGENR Circuit Pack Detailed Level Procedure: DLP-519
Install Software (Initial
Installation/Upgrade/Change) into CIT and
FT-2000 Network Element Operations: NTP-002
Install/Remove Apparatus (Circuit Pack) Blank Detailed Level Procedure: DLP-533
Install/Remove Lightguide Buildout Detailed Level Procedure: DLP-512
Introduction to the PC Detailed Level Procedure: DLP-529
Loop Back DS3 and/or EC1 Circuit(s) for Testing Detailed Level Procedure: DLP-525
Loop Back OC-12 Line(s) for Testing Detailed Level Procedure: DLP-549
Loop Back OC-3 Line(s) for Testing Detailed Level Procedure: DLP-538
Maintenance Philosophy Trouble Clearing: TAD-100
Make Manual Optical Loopback at FT-2000
Network Element Detailed Level Procedure: DLP-500
Merge Two OC-48 Rings Operations: NTP-009
Obtain State Report Detailed Level Procedure: DLP-516
Optical Upgrade From STS-3 to STS-1
Granularity Operations: NTP-010
Perform Automatic Low-Speed Cabling (Fiber)
Test Detailed Level Procedure: DLP-503
Perform Local Automatic Turnup Test Detailed Level Procedure: DLP-502
Perform Provisioning Detailed Level Procedure: DLP-505
Perform Provisioning Test Office Alarm Operation Detailed Level Procedure: DLP-504
Power Down/Power Up an Optical Network
Element Detailed Level Procedure: DLP-551
Properly Terminate DS3 and/or EC1 Outputs Detailed Level Procedure: DLP-520
FINDYOURJOBINTHELISTBELOW...........THENGOTO
To Next Page
Loading...