Logging Measurement Data and Image Data
402
FQ2-S/CH User’s Manual
Setting Logging Conditions
Use the following procedure to set the conditions for the measurement data, image data, and statistical data
that will be logged.
Some of these operations and settings are the same as for file logging.
Setting Logging Conditions: p. 395
Selecting the Measurement Data To Log
With recent results logging, you can select the measurement pre-processing, measurement data, or calculation
items to be logged. These settings also apply to file logging.
Selecting the Measurement Data To Log: p. 396
Starting Logging
Logging will be started as soon as the conditions for logging have been set.
If the settings are saved, logging will start automatically the next time the power supply is turned ON.
Item Description
Statistical data
Statistical data, such as the number of measurements, the number of NG overall
judgments, and the NG rate, since the power supply was turned ON will be
logged.
ON : Statistical data will be displayed (Default).
OFF: Statistical data will not be displayed.
Logging image
(image data)
These are the same as for file logging.
Logging data
(measurement data)
The logging parameters for image data and measurement data are the same as those for file logging.
Note
To Next Page
Loading...
Need help?
General
