Caster Table Type M41 (D3GW03)
SM 2-65 D0CA/D0C9/D0C8/D0CB
4. Place the main machine [B] on the caster table [A].
5. Loosen the screws of the stabilizer [A] on the front side, lower the stabilizer until the
machine is stable, and tighten the screws.
6. Loosen the screws of the stabilizers on the left, right, and rear sides, lower the stabilizers,
and tighten the screws.
Remove the handle [A] attached to the back of the caster table.
1. Attach the handle [A] removed in step 1 to the screw holes on the front of the caster table.
To Next Page
Loading...
