Controller Options
D0CA/D0C9/D0C8/D0CB 2-144 SM
User Tool Settings for Wireless LAN
Enter the UP mode. Follow the procedure below to perform the initial interface settings for IEEE
802.11a/g/n. These settings take effect every time the machine is powered on.
• You cannot use the wireless LAN if you use Ethernet.
1. Press the "Settings" icon.
2. Press "System Settings".
• Select "Network/Interface"> "IEEE802.X Authentication" > "IEEE802.X
Authentication for Ethernet". Either the Ethernet or the wireless LAN must be set
to "Inactive".
3. Select "Network/Interface" > "Control Panel:Wireless LAN". Only the wireless LAN options
show.
4. Set the “Communication Mode”.
5. Enter the SSID setting. (The setting is case sensitive.)
6. Set the “Ad-hoc Channel”. You need this setting when Ad Hoc Mode is selected. The
allowed range for the channel settings may vary for different countries.
Region A (mainly Europe and Asia)
Range: 1-13, 36, 40, 44 and 48 channels (default: 11)
In some countries, only the following channels are available:
Range: 1-11 channels (default: 11)
Region B (mainly North America)
Range: 1-11, 36, 40, 44 and 48 channels (default: 11)
7. Set the “Security Method” to specify the encryption of the Wireless LAN.
• The WEP (Wired Equivalent Privacy) setting is designed to protect wireless data
transmission. The same WEP key is required on the receiving side to unlock encoded
data. There are 64 bit and 128 bit WEP keys.
Range of Allowed Settings:
- 64 bit: 10 characters
- 128 bit: 26 characters
• Specify “WPA2” when “Communication Mode” is set to “Infrastructure Mode”. Set the
“WPA2 Encryption Method” and “WPA2 Authent. Method”.
WPA2 Encryption Method: CCMP (AES) is fixed.
WPA2 Authent. Method: Select either “WPA2-PSK” or ”WPA2”.
If you select “WPA2-PSK”, enter the pre-shared key (PSK) of 8 -63 characters in ASCII
code. When “WPA2” are selected, authentication settings and certificate installation
settings are required.
8. Press "Wireless LAN Signal Status" to check the machine’s radio wave status using the
To Next Page
Loading...
