Ricoh IM C300

Mechanism
SM 8-25 D0CA/D0C9/D0C8/D0CB
Smart
Operation
Panel
Shutdown Functions
The shutdown functions and their uses are as follows.
Shutdown
mode
Use Operation
Normal
Shutdown
Same as shutdown by users. Turn the main power switch (SW1)
OFF.
Forced
shutdown
When normal shutdown does not
complete even though you waited a long
time.
Hold the main power switch
(SW1) 6 seconds or longer.
Shutdown for
parts
replacement
• When you have to disconnect the
power cord from the power outlet,
such as when replacing parts.
• When you want to start the machine
normally and then enter recovery
mode, without changing the Startup
mode in [Control Panel Startup
Mode]. (For updating control panel
firmware)
Turn the main power switch (SW1)
OFF while holding down [Stop].
Continue to hold down the [Stop]
key until the shutdown screen is
displayed.
Shutdown for
software
update
When you are going to turn ON the MFP
within 5 minutes for updating the MFP
firmware or package.
(Use shutdown for parts replacement if
you are updating the control panel
firmware.)
Turn the main power switch (SW1)
OFF while holding down the [EX1]
key. Continue to hold down the
[Stop] key until the shutdown
screen is displayed.
The MFP is equipped with a function to shut down safely in order to:
• Prevent damage to the file systems in the HDD and the NAND flash memory.
• Prevent paper from being left inside the body of the MFP (except when paper is jammed).
The shutdown process begins when the main power switch (SW1) is pressed. To make a forced
shutdown, press and hold the main power switch (SW1) for 6 seconds. However, if you force a
shutdown during the shutdown process, data being processed may be lost. Forced shutdown is
to be used to shut down the MFP without disconnecting the power cord when the shutdown
process cannot be completed.