SD Card Options
SM 2-163 D0CA/D0C9/D0C8/D0CB
• Supervisor login password
• Administrator login name
• Administrator login password
If any of these settings is at a factory default value, tell the customer these settings must be
changed before the installation procedure.
3. Make sure that “Admin. Authentication” is ON.
[Settings] > [System Settings] > [Settings for Administrator] > [Authentication/Charge] >
[Administrator Authentication/User Authentication/App Authentication] > [Administrator
Authentication Management] > [Admin. Authentication]
If this setting is O FF, tell the customer this setting must be ON before the installation
procedure.
4. Make sure that “Administrator Tools” is enabled (selected).
[Settings] > [System Settings] > [Settings for Administrator] > [Authentication/Charge] >
[Administrator Authentication/User Authentication/App Authentication] > [Administrator
Authentication Management]> [Available Settings]
If this setting is disabled (not selected), tell the customer this setting must be enabled
(selected) before the installation procedure.
Seal Check and Removal
Make sure that the box seals are attached to the box properly. If those are not, this option has
an initial failure.
“VOID” [B] can be seen when the seal is removed.
Before installation, you must make sure the box seals have not been opened since they were
initially sealed at the factory.
1. Check the box seals [A] on each corner of the box.
• Make sure that a tape is attached to each corner.
To Next Page
Loading...
