Main Machine Installation: Installation Procedures
D0CA/D0C9/D0C8/D0CB 2-34 SM
Value Mode Descriptions
Color Total Counter
B&W Total Counter
2 Coverage Count Color Total Counter
B&W Total Counter
Color Coverage Counter 1
Color Coverage Counter 2
Color Coverage Counter 3
7 Coverage Count (YMC) Color Total Counter
B&W Total Counter
Color Coverage Counter 1 (YMC)
Color Coverage Counter 2 (YMC)
Color Coverage Counter 3 (YMC)
2.4.10 SETTINGS FOR @REMOTE SERVICE
• Prepare and check the following points before visiting the customer. For details, ask
the @Remote key person.
Check points before making @Remote settings
1. The setting of SP5-816-201 in the mainframe must be "0".
2. Print the SMC with SP5-990-002 and check the device ID2 from SP5-811-003, make sure it
is programmed correctly.
• 6 spaces must be put between the 3-digit prefix and the following 8-digit number (e.g.
xxx______xxxxxxxx).
• ID2 (SP5-811-003) and the serial number (SP5-811-001) must be the same (e.g. ID2:
A01______23456789 = serial No. A0123456789)
• Make sure to shut down and reboot the machine once before printing the SMC.
Otherwise, the latest settings may not be collected when the SMC is printed.
3. The following settings must be correctly programmed.
• Proxy server IP address (SP5-816-063)
• Proxy server Port number (SP5-816-064)
• Proxy User ID (SP5-816-065)
• Proxy Password (SP5-816-066)
4. Get a Request Number
Execute the @Remote Settings
1. Enter the SP mode.
2. Input the Request number obtained from @Remote Center GUI, and then enter [OK] with
To Next Page
Loading...
