Image/Paper Transfer
D0CA/D0C9/D0C8/D0CB 4-132 SM
4.12.6 PAPER TRANSFER ROLLER UNIT
Before replacing the paper transfer roller unit, reset the PM counter.
1. Turn the power ON.
2. Reset the PM counter. (Refer to Replacement Procedure of the PM/Yield Parts)
3. Turn the power OFF.
Open the right door.
• If you find paper dust on the registration section when you open the duplex unit,
remove the dust. Otherwise, the dust causes lines on the image.
1. Remove the paper transfer roller unit [A] while holding the knobs on both ends of the paper
transfer roller with your fingers.
To Next Page
Loading...
