Main Machine Installation: Important Notice on Security Issues
SM 2-7 D0CA/D0C9/D0C8/D0CB
2.2 MAIN MACHINE INSTALLATION: IMPORTANT
NOTICE ON SECURITY ISSUES
2.2.1 OVERVIEW
To increase the security of the MFP and ensure the customer sets an administrator password,
an administrator set/change prompt is displayed when the machine is turned on for the first
time. .
After the customer sets the administrator/supervisor login password, the home screen will be
displayed. However, customers can remove the administrator password setting screen with the
following the procedure.
1. On the Program/Change Administrator screen, press [Change] next to Supervisor and then
touch [OK] without inputting any password.
2. Touch [OK] again when the Confirm password display shows up.
3. For Administrator 1, do the same procedure as steps 1 and 2.
4. Press the [OK] button, and then turn the power OFF/ON.
SP5-755-002 (Display Setting: Hide Administrator Password Change Scrn) allows you to
skip this screen temporarily and continue the installation procedure without setting an
administrator password. However, the Program/Change Administrator screen appears every
time you turn the power OFF/ON if the password is not set.
• To enter the SP mode, there are two ways to display the numeric keypad on the
screen;
1. Press the "Document Server" icon.
2. Press and hold the button [A] located on the left side of the operation panel and
"Check Status [B]" at the same time.
To Next Page
Loading...
