Image Adjustment
D0CA/D0C9/D0C8/D0CB 4-254 SM
1: Feed direction
SP Code What It Does Adjustment Range
SP6-006-014 Trailing Edge Erase Width (1-Pass):Face ± 5.0 mm
SP6-006-015 Trailing Edge Erase Width (1-Pass):Back ± 5.0 mm
ADF Sub-scan Magnification
1. Put the temporary test chart on the A D F. Then make a copy from one of the feed stations.
2. Check the magnification ratio. Adjust with SP6-017-001(ADF Adjustment L-Edge Mag) if
necessary.
• Standard: ±5.0%
• Reduction mode: ±1.0%
• Enlargement mode: ±1.0%
4.20.4 REGISTRATION
Adjustment Standard
[1]: Feed direction, [2]: Image area
Make sure that the registration is adjusted within the adjustment standard range.
After doing the registration adjustment, do the Erase Margin Adjustment in the next section.
Leading edge (sub-scan direction):
B = 3.25 ± 2.75 mm
To Next Page
Loading...
