Firmware Update (Smart Firmware Update)
SM 5-13 D0CA/D0C9/D0C8/D0CB
Maintenance
5.4 FIRMWARE UPDATE (SMART FIRMWARE UPDATE)
• A HDD unit must be installed on the machine to enable the SFU or the package
firmware update via media device.
5.4.1 OVERVIEW
Smart firmware update (SFU) is a system to download a firmware package. Since downloading
the package takes time, SFU lets you schedule the download to take place when the machine is
not in use, such as at night or at the weekend.
There are the following methods of updating using SFU.
1. Immediate Update: To update and download the firmware when visiting.
2. Update at the next visit: To set the date and time for firmware downloading. The firmware
will be automatically downloaded beforehand and updated at the following visit.
"Update at the next visit" is recommended since firmware download may take some
minutes due to the network condition.
• SFU requires the connection to @Remote via a device which has the embedded
@Remote communicating function. When a machine is connected to @Remote via an
intermediate device (RC Gate), the SFU function is disabled.
5.4.2 IMMEDIATE UPDATE
Enter the [Firmware Update] menu in the SP mode and update the package firmware.
• The [Firmware Update] button will appear even when a machine is connected to
@Remote with a device which does not have an embedded @Remote communicating
function.
• If an error code is displayed, refer to Firmware Update (Error Screens During
Updating).
1. Enter the SP mode.
To Next Page
Loading...
