Main Machine Installation: Installation Procedures
D0CA/D0C9/D0C8/D0CB 2-26 SM
[A]: Black, [B]: Cyan, [C]: Magenta, [D]: Yellow
3. Check that the front cover is closed and execute SP2-111-004 (Forced Line Position Adj.:
Mode d).
4. Check the SP values for SP2-117–001 to 004 and repeat steps 2 to 4 until the SP values
for all colors fall within ± 5 (Target value: 0).
5. Exit the SP mode.
6. Reattach all parts that you removed in the above steps.
7. Print the test chart and check the image quality.
• Do not touch the laser units while installing the paper exit tray. If the laser units
move, the color skew might have to be adjusted again.
Open the front cover.
1. Remove the paper exit front cover, paper exit upper cover and paper exit tray. (Paper Exit
Front Cover/Paper Exit Upper Cover/Paper Exit Tray for IM C400SRF)
2. Remove the staple unit [A].
3. Close the front cover.
4. Insert a screwdriver through the adjustment hole and adjust the skew of the laser unit as
follows.
To Next Page
Loading...
