Service Program Mode
D0CA/D0C9/D0C8/D0CB 3-2 SM Appendices
1. Press and hold the button [A] located at the left side of the operation panel and "Check
Status [B]" at the same time, until the number keyboard is displayed.
2. Enter the key code for SP mode.
For details of the key code to enter the SP mode, ask your supervisor.
Exiting SP Mode
• Press "Exit" on the LCD twice to return to the copy window.
3.1.2 TYPES OF SP MODES
• System SP: SP modes related to the engine functions
• Printer SP: SP modes related to the controller functions
• Scanner SP: SP modes related to the scanner functions
• Fax SP: SP modes related to the fax functions
Select one of the Service Program modes (System, Printer, Scanner, or Fax) from the touch
panel as shown in the diagram below after you access the SP mode. This section explains the
functions of the System/Printer/Scanner SP modes. Refer to the Fax service manual for the Fax
SP modes.
To Next Page
Loading...
