Main Machine Installation: Installation Procedures
SM 2-23 D0CA/D0C9/D0C8/D0CB
4. Pull out the paper feed tray until it stops.
5. Release the side fences.
6. Load paper into the paper feed tray.
7. Set the side fences according to the paper size while pressing the unlock lever.
8. Set the end fence according to the paper size while pressing the unlock lever.
Paper Registration
Adjust the registration setting for paper trays.
• SP1-002-001 (Side-to-Side Registration By-pass Table)
• SP1-002-002 (Side-to-Side Registration Paper Tray 1)
• SP1-002-005 (Side-to-Side Registration Duplex)
If one or more optional paper trays is installed, do the following SPs as well:
• SP1-002-003 (Side-to-Side Registration Paper Tray 2)
• SP1-002-004 (Side-to-Side Registration Paper Tray 3)
• SP1-002-005 (Side-to-Side Registration Paper Tray 4)
• Refer to the “Registration” section in Chapter 4 for how to adjust the SP setting.
Automatic Color Calibration (ACC)
Be sure to execute color registration when installing the machine.
- Copier mode -
1. Press [Settings] on the Home screen.
2. Press [Maintenance] > [Auto Color Calibration]
3. Press [Start Auto Calibration] for "Copier Function".
4. Press [Start Printing] to print the test pattern.
The test pattern is printed in A4 size.
5. Clean the exposure glass.
6. Put the test pattern on the exposure glass, and then put 10 sheets of white paper on the
test pattern.
This ensures the precise ACC adjustment. Close the A DF.
To Next Page
Loading...
