Updating JavaVM
D0CA/D0C9/D0C8/D0CB 5-42 SM
6. Remove the SD card slot cover [A] (Coin screw x 1).
7. Remove VM Card Type M37 from SD Card Slot 2 [A: Lower Slot].
5.8.3 UPDATING JAVAVM AND INSERTING THE VM CARD
1. Insert VM Card Type M37 into the SD memory card reader/writer of the PC.
2. Check that the SD memory card reader/writer is detected on the PC, and then write down
the drive letter. (If the SD memory card reader/writer is detected as (F:), the drive letter is
"f")
3. Download the update modules from the Firmware Download Center.
4. Unzip the downloaded file, and then execute the .exe file.
5. The folder is generated.
6. Execute the .bat file in the folder.
7. Input the drive letter following the message "Please input drive letter of SD card [a - x]: ". (If
the SD memory card reader/writer is detected as (F:), input "f")
8. Press the [Enter] key to start updating Java VM.
It takes 3 minutes to update Java VM.
9. After completing the update, remove VM Card Type M37 from the SD memory card
To Next Page
Loading...
