System Maintenance
SM 8-27 D0CA/D0C9/D0C8/D0CB
8.3 SYSTEM MAINTENANCE
8.3.1 MAINTENANCE MODES
Service program (SP) modes for the Smart Operation Panel are as follows:
Mode Use Notes
SP Mode (MFP) SP modes for the MFP
(controller, engine)
The numeric keys are required to enter this
mode. Display the application where soft keys
are displayed or the soft keys of the SP mode.
Service mode
(operation
panel)
SP modes for the Smart
Operation Panel.
• Changing SP mode
settings in the Screen
Features Settings menu.
• Installing and updating
applications that can be
installed
Same as above
Recovery mode Maintenance modes for the
Android OS
• Updating firmware
• Initializing all data
-
8.3.2 LOGIN TO/LOGOUT FROM CONTROL PANEL SERVICE
MODE
Login
In the same way as you log in to the SP Mode on the MFP, you use the soft keys to enter a
combination of numbers in order to login to the service mode of the control panel.
• You cannot log in to the service mode of the control panel when one of the following
screens is displayed.
• Stop All Jobs
• Settings
• Address Book Management
Use the numeric keys on one of the following screens.
• Soft keys on the application screen where soft keys appear
• Soft keys for the control panel’s service mode (displayed by pressing both the [EX3] key
and [Check Status] at the same time)
To Next Page
Loading...
