Mechanism
D0CA/D0C9/D0C8/D0CB 8-26 SM
This MFP has two additional shutdown functions to facilitate maintenance.
Shutting down the MFP for parts replacement (Starting up in Normal mode when Quick
mode is selected)
When Quick mode is selected, the MFP prepares for the next startup when it shuts down. This
causes the shutdown process to take longer than when Normal mode is selected.
If you need to disconnect the power cord after shutdown in order to replace parts or for other
reasons, you can use the following procedure to shut down the MFP just like you do in Normal
mode. This shortens the time it takes to shut down the MFP.
• Procedure
Turn the main power switch (SW1) OFF while holding down the [Stop] key on the control
panel. Continue to hold down the [Stop] key until the shutdown screen is displayed.
Shutting down the MFP for software updates (Shutting down the MFP with the control
panel in Sleep mode)
If you are going to turn ON the MFP within 5 minutes, you can use the following procedure to
shut down the MFP with the control panel in Sleep mode.
• Procedure
Turn the main power switch (SW1) OFF while holding down the [EX1] key. Continue to hold
down the [EX1] key until the shutdown screen is displayed.
• You must turn ON the MFP within 5 minutes.
• If more than 5 minutes has elapsed after shutting down the MFP using the above
procedure, the machine starts up in Normal mode even if Quick mode is selected.
To Next Page
Loading...
