Maintenance Tables
SM Appendices
2-5 D0CA/D0C9/D0C8/D0CB
Preventive
Maintenance
The parts mentioned in these tables have a target yield. However, the total copy/print volume
made by the machine will not reach the target yield within the machine's targeted lifetime if the
machine is used under the target usage conditions (ACV, color ratio, and P/J). So, these parts
are categorized not as PM parts but as yield parts (EM parts). In this table, the parts with “Y” are
yield parts and the parts with “P” are PM parts.
ADF
The PM count for the following items is based on the number of originals fed:
Item PM/Yield
Parts
30k
45k EM Remarks
Friction pad Y* R C Wipe with a dry cloth.
ADF pick-up roller Y* R C Wipe with a damp
cloth.
ADF feed roller Y* R C Wipe with a damp
cloth.
ADF entrance roller C Wipe with a damp
cloth.
Pre-scanning roller (front side/ rear
side)
C Wipe with a damp
cloth.
ADF exit roller C Wipe with a damp
cloth.
* The actual lifetime of these parts depends on the type of paper used and machine operation.
Therefore, these parts are treated as Yield Parts.
Scanner Unit
Item PM/Yield Parts EM Remarks
Exposure glass C Clean with a cleaning cloth.
ADF exposure glass C Clean with a cleaning cloth.
PCDU
The PM count for the following items is based on the sheets of copy paper fed:
Item PM/Yield
Parts
36k 60k EM Remarks
PCDU
(K)
P R The PCDU (K) for IM C300 series is different from IM
C400 series. Make sure of the correct part number
before ordering it.
PCDU
(C)
P R At color ratio 30%, the replacement interval is 120k.
To Next Page
Loading...
