System Maintenance
D0CA/D0C9/D0C8/D0CB 8-52 SM
Update method Features Control
panel
firmware
Applications
Site. When administrator authentication is
enabled, an administrator privilege is required
to start Application Site. If you log in to the
operation panel service mode, however, you
can use it with CE privilege.
*1 Update can only be done by using a package file.
The following two methods can be used for updating the firmware.
• Update from a media
• Installation/update from Application Site
The following three methods can be used for updating an application.
• Installation/update from a media
• Installation/update from the eDC Server
• Installation/update from Application Site
Installation/Update from a Media
Creating a media card for update
1. Download the update modules from the Firmware Download Center.
2. Create a folder named “romdata” in the root directory of the media.
3. Put the application zip file in the "romdata" folder.
Do not unzip the zip file.
Update procedure
1. Log in to the control panel in service mode.
2. Insert the SD card into the SD card slot of the control panel.
3. Select [Apps] > [Install] > [Install from SD Card].
4. Select the application you want to install or update, and then press [Install]
5. The installation or update results are displayed.
6. Check that the application is correctly installed or updated, and then press [reboot
operation panel].
This method uses the package update function to update the control panel firmware
and/or applications. The package update function is provided by the controller.
Update is done in the following order:
1. Controller firmware
2. Applications
3. Control panel firmware
To Next Page
Loading...
