Electrical Components
SM 4-217 D0CA/D0C9/D0C8/D0CB
&
Adjustment
setting before the replacement.
- a. SP5-045-001 (Accounting counter: Counter Method)
- b. SP5-302-002 (Set Time: Time Difference)
• Because the PM counters have been reset during NV-RAM replacement, it is
necessary to replace all the PM parts for proper PM management.
• If a message tells you need an SD card to restore displays after the NVRAM
replacement, create a “SD card for restoration” and restore with the SD card.
Refer to “Encryption Key Restoration”
31. Execute the ACC (Copy).
32. Execute the ACC (Printer).
33. Cycle the power OFF/ON.
4.19.4 BICU (PCB1)
1. Remove the rear cover. (Rear Cover)
2. Slide the BiCU (PCB1) [A] in the direction of the blue arrow below and remove it.
To Next Page
Loading...
