SD Card Options
D0CA/D0C9/D0C8/D0CB 2-166 SM
Installation Procedure
• Turn OFF the main power and unplug the power cord from the wall socket. If the main
power is not turned OFF before installing, an electric shock or malfunction might occur.
1. Remove the SD card slot cover [A].
2. Insert the SD card (PictBridge) in SD slot 1 (upper) with its label face to the front of the
machine.
Merge the SD card contents if necessary. (SD Card Appli Move)
3. Turn ON the power.
4. Attach the SD card slot cover.
5. Make sure that the machine can recognize the option. (see Check All Connections at the
end of this section)
2.21.5 POSTSCRIPT3 UNIT TYPE M41 (D0CJ-26, -27, -28)
Overview
This machine is equipped with a clone program for emulating Adobe PostScript/PDF (hereafter
“Clone PS”) as a standard feature. So, by factory default, it can print using PostScript 3 and
PDF Direct Print, in addition to RPCS.
However, the variety and number of built-in fonts (device fonts) differ between Adobe PS and
Clone PS, sometimes resulting in different printing results.
The PostScript3 Unit Type M41 is an available option to address the possible customer needs
listed below.
• When the customer wants to use device fonts supplied with Adobe PS.
• Since forms and ledgers have been created based on device fonts supplied with Adobe PS,
a changeover to Clone PS requires a redesign of these documents.
• From the viewpoint of a precise printing operation, it is impossible to accept any differences
in output results in comparison with Adobe PS.
To Next Page
Loading...
