ADF
D0CA/D0C9/D0C8/D0CB 4-52 SM
6. Disconnect the FFC [A] from the relay board (PCB12).
Disconnect the FFC for the relay board (PCB12) by pulling it out straight, because it does
not have a lock mechanism.
When reassembling, the FFC must be connected straight.
7. Remove the shoulder screw for fixing the ADF.
8. Remove the ADF unit [A] from the machine.
When Installing the ADF
1. Open the ADF.
2. Do the following steps:
• Place the platen sheet [A] on the exposure glass.
To Next Page
Loading...
