Anti-condensation Heater
SM 2-105 D0CA/D0C9/D0C8/D0CB
2.17 ANTI-CONDENSATION HEATER
2.17.1 ACCESSORY CHECK
All the accessories required to install the Anti-condensation Heater are available as the
following parts. Order each part separately.
No. Description Q'ty Part Number
1 Junction Harness 1 D1965265*
1
2 Heater Power Switch 1 12042570
3 Clamp 1 11050511
4 Screw 1 08010231
5 Heater kit 1 D1175097: EU/AA/KOR/CHN
D1175091: NA/TWN
• *1 This harness (P/N: D1965265) is also used as a harness for dehumidification heater
(PFU), and dehumidification heater (main unit) . If you have already ordered this
harness for these heaters, it is not necessary to order this harness again at this time.
2.17.2 INSTALLATION PROCEDURE
• Do not lift the machine with any optional paper feed units attached
If the machine already has one or more optional paper feed unit(s) attached, be sure to
disconnect the machine and paper feed unit(s), and lift them up separately when
moving/transporting. Otherwise, the handle of the paper feed unit will break due to the
mainframe’s weight, and it can cause an injury.
To Next Page
Loading...
