Main Machine Installation: Installation Procedures
SM 2-27 D0CA/D0C9/D0C8/D0CB
Turn the knob for any color with a value other than "0", until it reads "0".
• Turning the knob clockwise by 90 degrees changes the SP value by -1.
• Turning the knob counter-clockwise by 90 degrees changes the SP value by +1.
• A click is felt every 90 degree rotation.
[A]: Black, [B]: Cyan, [C]: Magenta, [D]: Yellow
5. Check that the front cover is closed and execute SP2-111-004 (Forced Line Position Adj.:
Mode d).
6. Check the SP values for SP2-117–001 to 004 and repeat steps 4 to 6 until the SP values
for all colors fall within ± 5 (Ta r get value: 0).
7. Exit the SP mode.
8. Reattach all parts that you removed in the above steps.
9. Print the test chart and check the image quality.
• Do not touch the laser units while installing the paper exit tray. If the laser units
move, the color skew might have to be adjusted again.
To Next Page
Loading...
